How to apply Fix Pack in DQ+

Before applying the fix pack, please read the fix pack's release notes for potential instructions specific for that fix pack. These instructions will be in a section title either "Special Installation Instructions" or "Pre-Installation Steps" within the release notes.

Below are the steps to apply Fix Pack;

1. Download / Upload the Fix pack in Maintenance Node. Preferably upload it under "/tmp".
   
   
2. Change the ownership of FP to maintenance user (if other user is the owner).
   
   
3. Execute chmod +x {FP_Name}.sh
   
   
4. Extract the Fix Pack by executing ./{FP_name}.sh. The extraction process will ask to over write /opt/infogix/sagacity-3.0. Press "Y".
   
5. The above extract process will extract the Fix Pack under
   /opt/infogix/sagacity-3.0/maintenance/
   
   
   
6. Change directory to
   "/opt/infogix/sagacity-3.0/maintenance/{extracted_fix_packs}/bin/"
   
   
7. Execute "./apply-patch" , the shell will kick-off the Fix Pack process.
   
   
   
   
   
8. The above process will reboot the Applications by itself, but it is recommended to Stop/Start the Application before start using the Application.
   
   
9. Verify the above applied FP, by login into the Application > Help > About.
   

Important Note: Make sure maintenance user has "Password-less sudo access" to apply these FPs. This sudo access issue has been addressed under Fix Pack 5 of DQ+ 3.0. All earlier patches require sudo access.