While using Data360 Analyze you may come across the following error:
A data connection is defined within the composite which is attached to an input
or output on the node "xxx". However, the referenced input / output cannot be
located on the node. This has most likely occurred because the input / output on
the node has been removed from a parent library node. If you are unable to
resolve the problem within the data flow, it is recommended that you use
the "Apply Auto-Fixes" option.
This error can occur when:
- you are missing a library node
- a node is removed within a library node
The apply auto-fixes should resolve it, however after applying it you should save the data flow and try to re-run it. If that doesn't then you may need to find the erroring node and perform some editions.
The error message should point at the node in question. Depending on the version you're running, you may be able to navigate from the error panel to the node.
The error message presented appears on execution, so errors persist until the next execution. Therefore, until a rerun is attempted, the errors shown will be from the previous execution, where issues may have been fixed since that last execution attempt.